It is initialized and off shortly after 5 s. Voltage on pin 8 of U36 memory is 2.2V. Tension in PL7 coil is 5v and PL6 coil is 3.3V. Measurements obtained without the use of the processor.

Try this:
http://t-hex.livejournal.com/174832.html

soldered components in FQ6 and FQ7 around but the problem continues. I noticed that seem to lack a component that should be a resistor near the FQ7 marked with a circle watching the picture. I think it's a 100k connected in FQ7 pin gate 2

---

Posted after 4 minutes 37 seconds:
have this component in the circuit and at the plate?

Marked resistor must be 100k (PR28).

put a resistor 100k taken from another board scrap and turn on the notebook the same again work perfectly. Many thanks to friend 2N3904. Topic completed.