Полагаю что это RT9611CGQW, но не уверен в этом.

Поэтому попробую заказать. будем надеяться, что если заменить все разом, то поработает)

ПОработает, недельку... Я уже на 3 картах пробовал и менял все. Говорю - бесполезно.

drivers are most likely faulty.

у кого карты с подобными проблемами - повтор по умиранию кучки этих rt9611c через достаточно продолжительный промежуток времени - отпишите в лс, есть догадка, почему оне мрут, надо пробовать собрать статистику по "доработке".

Maybe it will help someone, my story:
I received such a card a year ago with a broken PU113
There was a donor, Asus R7-260X with the same 4J =
changed one with a strapping (2.2 ohms) and it bogged down, it lasted for a couple of months - it returned already with broken 113 and 114, I bought a new set, changed it with rezyuks and put field workers 3052 top, 3058 bottom, worked for another month and again a pair of 113/114 flew away.
I bought a card for myself, put 4J with the donor's 260th balance and ... 2 days. and again.
Finally) I noticed that in the 260th the harness is fully consistent with the documentation for this richtek, that is, the power supply is limited to 4.7 ohms, in the DC voltage boost chain there is not a zero resistor, but also 4.7 ohms and no external diodes and additional conduits.
in short, I did everything as it was in the 260th (changed (2.2 ohm and 0 ohm) to 4.7 ohm each, removed 0.01 and diodes) and also field workers put 7030AL up one by one and 5030 two down, and instead of 12V chokes, 8A fuses from the port and 12A from the power supply.
visible in the photo.
Haven't had any problems for a couple of months now.

кароче сделал все как у 260й было(поменял (2,2ом и 0ом) на 4,7ом каждый , удалил 0,01 и диоды) и еще полевики поставил 7030AL верх по одному и 5030 по два низ